HKS Logo

HKS EVC Boost Controller


HKS EVC Boost Controller 20th Anniversary Edition

The dominant king of boost controllers retains is throne! The new 20th-anniversary edition of the HKS EVC boost controller is everything the last version and a whole lot more! Consider these features:
 

  • High Boost Capability
  • Target Boost
  • Offset Function
  • Map Correction Mode
  • Dual Boost Mode Settings
  • Scramble Boost Function
  • External Scramble Boost Trigger compatible.
  • Metric or SAE selectable monitoring
  • Warning Function with Boost Drop Feature
  • Analog and Digital Boost Monitoring
  • Additional Digital Monitoring
  • Selectable Analog Monitoring
  • After Image Function
  • Peak Hold
  • Data Lock
  • Positive LCD display with LED Lighting
  • Dimmer Function
  • Rear Mounted Wiring harness
SETUP INSTRUCTIONS
MORE INFO !

Orders Over $150 Ship Free!*
Part # Description Price
45003-AK005 HKS EVC Boost Controller Standard $585.00
45003-AK007 HKS EVC Boost Controller Limited Edition
HKS 35th Anniversary with Yellow Display
$585.00
45003-AK006 HKS EVC Boost Controller Kit
Includes Easy Writer Software
$684.00
45003-AK009
**NEW!**
HKS EVC-S Boost Controller
Feature-rich entry-level electronic boost controller
$418.00
53002-AK001 HKS EVC Display Stand $12.97ea
Don't see what you're looking for?
Give us a call at (321) 725-3159 or

HKS EVC Boost Controller Setup

Follow these simple setup steps:

  1. Units of Measure - make sure you are selecting the correct unit of measure - PAS (kPa) or PSI.

  2. Wastegate Type - (S) is for swing valve or internal (actuator) wastegate type or (P) is for poppet valve or external wastegate type

  3. Standard Maximum Boost - is your "maximum" base wastegate spring pressure (NOT YOUR TARGET BOOST). It is recommended that you apply load to 3rd or 4th gear to obtain the base boost if you are not sure of your wastegate spring rate. An indicator will show your base boost where the P.H. is on the top of the screen. You can manually turn the knob also if you already know your base boost pressure.

  4. Target Boost - this is where you would enter your target boost. The range is from base boost to 36 PSI. (This mode automatically sets your volume A and B, but you can change it after your initial set-up). ** You must set your target boost ABOVE your base wastegate spring rate and cannot be the same as your factory or base rate.

  5. Initial Offset Value - the initial set-up offset value is different from the volume A and B offset settings. This step must be done to ensure you are obtaining your initial target boost. Your initial setting will be at 100%.

    You will now need to apply load to 3rd or 4th gear again to check that you are obtaining your initial target boost. An indicator next to the P.H. will blink showing you a real time boost pressure reading. If you are not reaching your target boost, you will need to turn the percentage(%) gain up by turning the knob clockwise. If your boost is going over your target boost, you will need to turn the percentage (%) gain down by turning the knob counter clockwise. Once you've matched the target boost you will need to push the knob once to finish the initial set-up.

    You are now done with your initial set-up and can now change from volume A and B by turning the knob left and right. To change the target boost for each setting, push the knob in once and turn the knob to your desired target boost, then push the knob once again to set it. That's it!

    BACK TO TOP