2-Stage Progressive Switch

FJO Racing Products is very pleased to offer our 2-Stage Progressive Switch.

The 2-STAGE PROGRESSIVE SWITCH is a digital controller that combines the functions of a throttle position sensing switch, two RPM window switches, and two progressive timers all into a very compact module. With the optional FJO high-current driver module, it can drive up to 40 amps per channel. The device also supports low-voltage OEM, V10 or 3 cylinder TACH signals without the need for additional adapters. It also works with most OEM throttle position sensors. The manual trigger input allows the driver to over-ride the controller and disable or enable stages manually.

The 2-STAGE PROGRESSIVE SWITCH is built for the racing environment to withstand heat, vibration, dirt and water. It is designed to operate over the temperature range from -40 to +185 degrees Fahrenheit (-40 to +85 degrees Celsius).

• 2 independent channels each programmable for ON/OFF or progressive ramp
• Programmable ramp times (0.1 - 10.0 sec)
• Integrated wide-open-throttle detection
• User configurable for rising or falling TPS signal
• Supports low voltage tach signals as low as 3 volts
• Works with irregular tach signals such as V10 and 3cyl
• Easy to use graphic set-up menus using PC USB
• Inputs for manual enable/disable or transmission brake, throttle position, tach signal
• Integrated LEDs for WOT, stage 1 RPM window, stage 2 RPM window
• High current solenoid driver with 40 amp load capacity

• Free updates/upgrades to software and controller firmware for the life of the product
• User installable firmware update using PC USB
• Built for the racing environment to withstand heat, vibration, dirt and water
• Free direct technical support

2-STAGE PROGRESSIVE MINI-CONTROLLER
WITH INTEGRATED HIGH CURRENT DRIVER

Activates 2 independent outputs based on TPS input and RPM (includes cables and software). PC configuration via USB connection. Includes integrated PROGRESSIVE driver.

2-STAGE PROGRESSIVE SWITCH KIT

Activates 2 independent outputs based on TPS input and RPM (includes cables and software). PC configuration via USB connection. (for PROGRESSIVE capability, add a KND0020)
...Discontinued!

HIGH CURRENT SOLENOID DRIVER KIT

Drives 2 pairs of solenoids from the 2-Stage Progressive Switch
(for adding progressive control to the KWS0020 SWITCH) (includes cable and connector)